Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 588

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Configuration on CE1 (Local CE Router)
Use the following commands on the local CE router (CE1) to configure the MPLS
L2VPN tunnel over LAG shown in Figure 123 on page 551.
Configuration on PE1 (Local PE Router)
Use the following commands on the local PE router (PE1) to configure the MPLS
L2VPN tunnel over LAG shown in Figure 123 on page 551.
552
MPLS L2VPN Tunnel over LAG Configuration Example
! Configure a virtual router CE1.
host1(config)#virtual-router ce1
!
! Specify the interface for the LAG bundle lag 1 that groups all Ethernet physical
! interfaces between CE1 and PE1.
host1:ce1(config)#interface lag 1
!
! Add the Gigabit Ethernet physical interfaces to the LAG bundle named lag 1.
! Assign an IP address and mask to it.
host1:ce1(config-if)#member-interface gigabitEthernet 2/1/0
host1:ce1(config-if)#member-interface gigabitEthernet 2/1/3
host1:ce1(config-if)#ip address 7.7.7.7 255.255.255.0
!
! Configure a virtual router PE1.
host1(config)#virtual-router pe1
!
! Enable MPLS on a virtual router in Global Configuration mode.
host1:pe1(config)#mpls .
!
! Configure the LSR to create topology-driven LSPs. Enabling LDP automatically
! creates topology-driven LSPs.
host1:pe1(config)#mpls topology-driven-lsp
!
! On PE1, configure a loopback interface, and assign an IP address and mask to
! the interface.
host1:pe1(config)#interface loopback 0
host1:pe1(config-if)#ip address 11.11.11.11 255.255.255.255
!
! Assign the router ID using the IP address you configured for the loopback
! interface.
host1:pe1(config)#ip router-id 11.11.11.11
!
! Create an IEEE 802.3ad LAG bundle, lag2, and add the Gigabit Ethernet physical
! interfaces to lag2. Configure MPLS tunneling on this side of the connection by
! issuing the mpls-relay command. When you issue the mpls-relay command, you
! must use a reachable local IP address and the same VC ID value (1) on both
! sides of the connection.
host1:pe1(config)#interface lag 2
host1:pe1(config-if)#member-interface gigabitEthernet 2/1/1
host1:pe1(config-if)#member-interface gigabitEthernet 2/1/2
host1:pe1(config-if)#mpls-relay 22.22.22.22 1
! Create another Gigabit Ethernet interface on PE1, specify VLAN as the