Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 573

5.
6.
7.
host1#show atm mcpt-timers
ATM Martini cell aggregation timers:
Timer1: 1500microseconds
Timer2: 2500microseconds
Timer3: 3500microseconds
host1#show atm subinterface atm 2/0.100
Interface ATM-Prot VCD VPI VCI
--------- -------- --- --- --- ------- ----- ---- -------------- ---------
ATM 2/0.100 ATM/MPLS 100
Maximum number of cells per packet: 100
Cell aggregation timeout timer:
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
Identifier (1, 2, or 3) of the ATM Martini cell packing timer that you want to
use to detect timeout of the cell collection threshold
host1(config-subif)#atm cell-packing 100 mcpt-timer 2
Create an MPLS relay connection to the loopback interface on the egress router.
The VC ID (1 in this example) must be the same on both sides of the connection.
host1(config-subif)#mpls-relay 6.1.1.1 1
host1(config-subif)#exit
Repeat Steps 1 through 5 on the egress router, creating an MPLS relay connection
to the loopback interface on the ingress router.
The values you configure for the ATM Martini cell packing timers and cell
concatenation parameters need not be the same on the ingress and egress
routers, although matching values are permitted. The virtual connection ID (VC
ID) value in the mpls-relay command, however, must be the same on the ingress
and egress routers.
host2(config)#atm mcpt-timers 1500 2500 3500
host2(config)#interface loopback 0
host2(config-if)#ip address 6.1.1.1 255.255.255.255
host2(config)#exit
host2(config)#interface atm 4/0.101
host2(config-subif)#atm pvc 101 0 101 aal0
host2(config-subif)#atm cell-packing 150 mcpt-timer 3
host2(config-subif)#mpls-relay 5.1.1.1 1
host2(config-subif)#exit
(Optional) Use the appropriate show commands to verify your configuration.
Circuit
Type Encap MTU
0 100 PVC AAL0 9180 lowerLayerDown Static
2
0
0
0
0
0
0
0
Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation
Chapter 7: Configuring Layer 2 Services over MPLS
Interface
Status Type
537