Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 376

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Table 45: show mpls Output Fields (continued)
340
Monitoring MPLS Status and Configuration
Field Name Field Description
LDP session retry Interval in seconds between attempts to set up an MPLS LDP
session
LDP session hold time Period in seconds for which an LSR maintains the session with its
LDP peer without receipt of any LDP message from that peer
LDP session keepalive Interval at which LDP sends session keepalive messages, in seconds
interval
LDP targeted hello hold LDP targeted-hello hold time, in seconds
time
LDP targeted-hello interval LDP targeted-hello interval, in seconds
Topology Driven LSP Status of topology-driven LSP, enabled or disabled
LSPs used for IP forwarding LSPs are placed in the IP routing table for forwarding plain IP traffic;
displayed only when the mpls ldp ip-forwarding command has
been configured. Indicates whether the LSPs that are used for IP
forwarding are host only, subject to a specified access list, or subject
to a specified prefix list.
RSVP is enabled This field and the following fields are displayed only when RSVP-TE
is enabled.
LSRID IP address of label-switched router
Re-optimization timer Frequency at which LSPs are checked for better paths
Tunnel retry Retry behavior to be performed during LSP setup
Refresh reduction State of RSVP-TE summary refresh reduction, OFF or ON
Message bundling State of RSVP-TE summary refresh message bundling, OFF or ON
Egress label Type of label advertised for the LSR that is the egress router for
the prefix, explicit-null or a non-null label
Hellos State of RSVP-TE hello feature, including the hello refresh interval
and hello miss limit
Graceful restart State of RSVP-TE graceful restart, OFF or ON
helper mode Graceful restart helper mode is enabled when this field is displayed
Restart time Graceful restart time, in milliseconds
Recovery time Graceful restart recovery time, in milliseconds