Enabling And Setting A Baseline For Mpls Next-Hop Table Statistics; Setting A Baseline For Mpls Tunnel Statistics; Enabling Statistics Collection For Policies Attached To Mpls Tunnels - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide

Enabling and Setting a Baseline for MPLS Next-Hop Table Statistics

To enable and set a statistics baseline for MPLS next-hop table entries:
1.
2.
By default, statistics are enabled for next hops depending on the protocol that created
the MPLS next hop. Statistics are not stored in NVS.
When enabled, the following statistics are maintained for each next-hop table entry:
There is no no version for the baseline mpls next-hop command. However, you
can disable the next-hop table statistics.
To disable the statistics for a specific MPLS next hop:

Setting a Baseline for MPLS Tunnel Statistics

To set a statistics baseline for MPLS tunnel statistics:
There is no no version.

Enabling Statistics Collection for Policies Attached to MPLS Tunnels

To enable collection of the following statistics for each policy attached to a tunnel:
318
Enabling and Setting a Baseline for MPLS Next-Hop Table Statistics
Issue the mpls statistics next-hop command to enable the statistics for a specific
MPLS next hop.
host1#mpls statistics next-hop 1046
Issue the baseline mpls next-hop command for a specific MPLS next hop.
host1#baseline mpls next-hop 1046
out packets and bytes
Issue the no mpls statistics next-hop command.
host1#no mpls statistics next-hop 1046
Issue the baseline mpls tunnel command.
host1#baseline mpls tunnel tunnel5
Issue the mpls statistics policy command.
host1#mpls statistics policy tunnel5
out discarded packets out error packets