Monitoring Ldp; Table 35: Show Ip Tunnel Route And Show Ipv6 Tunnel-Route Output; Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Table 35: show ip tunnel route and show ipv6 tunnel-route Output Fields
Related Topics

Monitoring LDP

Display information about LDP.
Purpose
To display LDP information:
Action
host1#show ldp
LDP
Field Name Field Description
Prefix IPv4 or IPv6 address prefix of network destination
Length Network mask length for prefix
Type Type of route; protocol
Next Hop IP address of the next hop to the route, whether it is a local interface
or another router; not displayed for IPv6 tunnel routing table
Dst or Distance Administrative distance for the route
Met or Metric Number of hops; metric
Interface Interface type and interface specifier
Tag Numeric tag that identifies route
Class Attribute of a route applied only as a result of set route-class clause
in a table map
show ip tunnel-route
show ipv6 tunnel-route
LSR ID is 80.0.0.2
FEC Deaggregation is off
Egress label: implicit-null
Label distribution control mode: ordered control
LDP session retry 0 times at interval 10
LDP session hold time: 180
LDP session keepalive interval: 20
LDP targeted-hello hold time: 45
LDP targeted-hello interval: 15
Topology Driven LSP enabled
LSPs used for IP forwarding
for host addresses only
Chapter 4: Monitoring MPLS
325
Monitoring LDP