Table 45: Show Mpls Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Topology Driven LSP enabled
LSPs used for IP forwarding
for host addresses only
Additional detail is shown when RSVP-TE is enabled:
RSVP is enabled
LSRID 10.1.1.1
Re-optimization timer is 3600
Tunnel retry forever at interval 5 if route is available
Tunnel retry forever at interval 5 if no route is available
Refresh reduction is OFF
Message bundling is OFF
Egress label is non-null
Hellos are on with an interval of 10000 and miss limit of 4
Graceful restart is ON
Restart time 60000 milliseconds
Recovery time 120000 milliseconds
Additional detail shown when RSVP-TE graceful restart helper mode is enabled:
RSVP is enabled
...
Graceful restart is ON (helper mode)
Table 45 on page 339 lists the show mpls command output fields.
Meaning

Table 45: show mpls Output Fields

Field Name
MPLS
LSR ID
Re-optimization timer
Label range
retry
Loop Detect
LDP
LSR ID
FEC Deaggregation
Egress label
Label distribution control
mode
Field Description
Status of MPLS, administratively enabled or disabled, and
configuration status
IP address of label-switched router
Frequency at which LSPs are checked for better paths
Range of platform label space
Retry behavior to be performed during LSP setup
Status of loop detection, enabled or disabled
This field and the following fields are displayed only when LDP is
enabled.
IP address of label-switched router
State of FEC deaggregation, on or off
Type of label advertised for the LSR that is the egress router for
the prefix, explicit-null or a non-null label
Label distribution control mode used by LDP for label distribution,
independent control or ordered control
Monitoring MPLS Status and Configuration
Chapter 4: Monitoring MPLS
339