Table 33: Show Atm Vc Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

ATM 3/0.8100
8000 circuit(s) found
Reserved VCC ranges:
Start Start End End
Interface VPI
--------- ----- ----- --- ---
ATM 2/0
ATM 2/0
2 reservation(s) found
To display a summary of all reserved VC ranges on the router, including those reserved
for MPLS use:
host1#show atm vc reserved
Reserved VCC ranges:
Start Start End End
Interface VPI
--------- ----- ----- --- ---
ATM 2/0
ATM 2/0
2 reservation(s) found
Table 33 on page 321 lists the show atm vc command output fields.
Meaning

Table 33: show atm vc Output Fields

Field Name
Interface
VPI
VCI
VCD
Type
Encap
Category
Rx/Tx Peak
Rx/Tx Avg
Rx/Tx Burst
Status
Start VPI
Start VCI
End VPI
End VCI
1 8100 8100 PVC SNAP UBR
VCI VPI VCI
2 100 2 102
3 300 3 303
VCI VPI VCI
2 100 2 102
3 300 3 303
Field Description
Interface type and number
Virtual path identifier
Virtual channel identifier
Virtual circuit descriptor
Type of circuit: PVC
Encapsulation method: AUTO, AAL5, MUX, SNAP, ILMI, F4-OAM
Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, CBR
Peak rate in Kbps
Average rate in Kbps
Maximum number of cells that can be burst at the peak cell rate
State of the virtual circuit: Up, Down
Starting virtual path identifier (inclusive) of the reserved VC range
Starting virtual circuit identifier (inclusive) of the reserved VC range
Ending virtual path identifier (inclusive) of the reserved VC range
Ending virtual circuit identifier (inclusive) of the reserved VC range
Monitoring ATM VCs and VPI/VCI Ranges Used for MPLS
Chapter 4: Monitoring MPLS
0 0 0 DOWN
321