Mpls Tunnel Profile Configuration Tasks - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

9.
10.
Related Topics

MPLS Tunnel Profile Configuration Tasks

If you anticipate having multiple tunnels to share the same configuration, you can
reduce your configuration time by using tunnel profiles to configure your tunnels.
In the profile, configure the tunnel endpoint last; anything configured after the tunnel
endpoint does not take effect until the tunnel is brought up the next time. You can
perform all other tasks in any order.
NOTE: Tunnel profile configuration tasks are relevant only for traffic engineering
networks.
(Optional) Associate a text description with the tunnel.
host1(config-if)#tunnel mpls description southshore
Configure the tunnel endpoint.
host1(config-if)#tunnel destination 10.12.21.5
MPLS Global Configuration Tasks on page 269
MPLS Interface Configuration Tasks on page 274
MPLS Tunnel Configuration Tasks on page 276
MPLS Tunnel Profile Configuration Tasks on page 277
Additional LDP Configuration Tasks on page 281
Additional RSVP-TE Configuration Tasks on page 286
interface tunnel
tunnel destination
tunnel mpls affinity
tunnel mpls autoroute announce
tunnel mpls autoroute metric
tunnel mpls bandwidth
tunnel mpls description
tunnel mpls no-route retries
tunnel mpls no-route retry-time
tunnel mpls path-option
tunnel mpls priority
tunnel mpls retries
tunnel mpls retry-time
Chapter 3: Configuring MPLS
MPLS Tunnel Profile Configuration Tasks
277