Ip Verify Binding; Ip Dhcp Snooping Limit - NETGEAR ProSafe GSM7228PS Cli Manual

Format
no ip dhcp snooping binding <mac-address>
Mode Global Config

ip verify binding

Use this command to configure static IP source guard (IPSG) entries.
Format
ip verify binding <mac-address> vlan <vlan id> <ip address> interface
<interface id>
Mode Global Config
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
Format
no ip verify binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode Global Config

ip dhcp snooping limit

Use this command to control the rate at which the DHCP Snooping messages come. The default
rate is 15 pps with a range from 0 to 30 pps. The default burst level is 1 second with a range of 1 to
15 seconds.
Default 15 pps for rate limiting and 1 sec for burst interval
Format
ip dhcp snooping limit {rate pps [burst interval seconds]}
Mode Interface Config
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the burst level,
to the defaults.
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-122