Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
4.1.2 interface range
This command gives you access to a range of port interfaces, allowing the same port
configuration to be applied to a set of ports.
Format
Mode
4.1.3 interface vlan
This command gives you access to to the vlan virtual interface mode, which allows certain
port configurations (for example, the IP address) to be applied to the VLAN interface.
Type a question mark (?) after entering the interface configuration mode to see the
available options.
Format
Mode
4.1.4 interface lag
This command gives you access to the LAG (link aggregation, or port channel) virtual
interface, which allows certain port configurations to be applied to the LAG interface.
Type a question mark (?) after entering the interface configuration mode to see the
available options.
Note: The IP address cannot be assigned to a LAG virtual interface. The interface
Format
Mode
4.1.5 auto-negotiate
This command enables automatic negotiation on a port.
Default
Format
Mode
4-2
interface range <unit/slot/port>-<unit/slot/port>
Global Config
interface vlan <vlan id>
Global Config
must be put under a VLAN group and an IP address assigned to the VLAN
group.
interface lag <lag id>
Global Config
enabled
auto-negotiate
Interface Config
v1.0, October 2008
Port and System Setup Commands