Set The Dynamic Address Aging Interval - NETGEAR M7100 Series User Manual

displayed as the first entry followed by the remaining (greater) MAC addresses. An
exact match is required.
Searched by VLAN ID. Select VLAN ID, enter the VLAN ID, for example, 100. Then
•
click the Go button. If the address exists, the entry is displayed as the first entry
followed by the remaining (greater) MAC addresses.
Searched by Port. Select Port, enter the port ID in Unit/Slot/Port format, for example,
•
2/1/1. Then click the Go button. If the address exists, the entry is displayed as the first
entry followed by the remaining (greater) MAC addresses.
The following table describes the nonconfigurable information displayed on the screen.
Table 106. Basic Address Table
Field
Total MAC Address
MAC Address
VLAN ID
Port
Status

Set the Dynamic Address Aging Interval

You can set the address aging interval for the specified forwarding database.

To set the address aging interval,
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
1.
example, 169.254.100.201.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
2.
the switch.
Launch a web browser.
3.
Enter the IP address of the switch in the web browser address field.
4.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
Enter the user name and password.
5.
M6100, M5300, and M7100 Series Managed Switches
Description
Displaying the number of total MAC addresses learned or configured.
A unicast MAC address for which the switch has forwarding and/or
filtering information. The format is a 6 byte MAC address that is
separated by colons, for example 01:23:45:67:89:AB.
The VLAN ID associated with the MAC address.
The port upon which this address was learned.
The status of this entry. The meanings of the values are as follows:
Static. The value of the corresponding instance was added by the
•
system or a user and cannot be relearned.
Learned. The value of the corresponding instance was learned,
•
and is being used.
Management. The value of the corresponding instance is also the
•
value of an existing instance of dot1dStaticAddress.
Configure Switching Information
281