No Decimal Point Display - Omron K3HB-H User Manual

Section 5 Functions and Operations

5.36 No Decimal Point Display

2
pvdp
L
(PVDP)
5-90
This function selects whether or not to display values below the
decimal point for present values, maximum values, and minimum
values.
If no display is selected, then numbers past the decimal point are
rounded off to display the nearest integer. Comparative judgments,
however, will use the decimal point.
Parameter
Decimal point display
pvdp
Parameter Setting Procedure
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
0" is displayed on the level/bank
• "
L
display to indicate the initial setting
level.
B Press the L [LEVEL] Key several
times to move to the display adjustment
level.
2" is displayed on the level/bank
• "
L
display to indicate the display
adjustment level.
C Press the M [MODE] Key several times
to change the PV display to "pvdp."
D Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
E Use the U [UP] Key to change the
position meter type setting.
F Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
Display adjustment level
Set value Meaning of set value
on
23.5 (Decimal point display)
off
24 (No decimal point display)
L
3 s min.
L
M
S
U S
M
H
0
L
0."
Displays "
L
sv. dsp
2
L
off
2."
Displays "
L
pvdp
2
L
off
pvdp
2
L
off
pvdp
2
L
on
sv. dsp
2
L
off