Omron K3HB-H User Manual page 123

Section 5 Functions and Operations
Important
Set the shot output time
(shot) to "0" to use the OFF
delay (off-d).
If set to anything else, off-
d (OFF delay) will be
disabled.
5-50
Parameter Setting Procedure
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
0" is displayed on the level/bank
• "
L
display to indicate the initial setting level.
B Press the M [MODE] Key several times
to change the PV display to "amov."
• This parameter is not displayed for the
initial status due to setting level
protect.
Refer to "Limiting Key Operations"
(P.5-102) for information on removing
setting level protect.
C Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U [UP] and S [SHIFT] Keys
to set the password "-0169." Press the
M [MODE] Key to move to the
advanced function setting level.
f" is displayed on the level/bank
• "
L
display to indicate the advanced
function setting level.
E Press the M [MODE] Key several times
to change the PV display to "shot."
F Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
G Use the U [UP] and S [SHIFT] Keys
to change the set value.
H Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
I Press the L [LEVEL] Key for at least
1 s to return to the initial setting level.
L
0
L
3 s min.
0."
Displays "
L
M
amov
0
L
0
S
amov
0
L
00000
U S
init
f
L
off
f."
Displays "
M
L
M
shot
f
L
0
S
shot
f
L
0000
U S shot
f
L
0010
M
out-n
f
L
n-o
L
0
L
1 s min.