Section 6 User Calibration
Calibration Flowchart
(K3HB-H)
Move to the calibration level.
Temporary registration of upper calibration limit
Temporary registration of lower calibration limit
Registration of temporarily registered upper and lower input limits.
Recalibrate.
Turn ON the power supply again and check operation in RUN level.
6-4
User calibration is performed according to the following flowchart.
Power ON
Aging
TC input
TC input
Calibration finished.
Operation
* The previous calibration value is not displayed when the status of
bias compensation values is being monitored. The display cannot
handle bias compensation values because they are temperature
readings rather than a count. This means the value that is read
during calibration is not a bias value, but the calibration value for the
main input.
(*Note)
Bias compensation value input