Omron K3HB-H User Manual page 95

Section 5 Functions and Operations
Important*
Measurement
range upper limit
Measurement
range lower limit
Power ON
Measurement value
RESET
TIMING
The PV display will show "-----" in no measurement status.
Remarks
* If the measurement exceeds the measurement range with the "input error enable" parameter
(s.err) set to OFF (disabled), then the upper or lower limit of the measurement range will be taken
as the measurement value. (The display will flash if the "input error enable" parameter is set to
OVER (overflow).) A sensor error will not occur in either case and a comparative value judgment
will be made on the displayed value. (Comparative results are not based on measurement values
shown with dotted lines.)
5-22
Peak-to-peak Hold
• The maximum and minimum values are held while measurement
is being performed (while the TIMING input is ON). When the
measurement has been completed (when the TIMING input turns
OFF), the measurement value is refreshed using the maximum
value minus the minimum value (i.e., the peak-to-peak value).
• When the maximum or minimum value exceeds the measurement
range during measurement, a sensor error will occur, a sensor
error will immediately show on the display, and all outputs will turn
OFF. Also, the measurement at that time will be invalid.
• Measurements are not performed and TIMING inputs are disabled
during RESET input.
P1-B1
P1
B1
0
Measurement invalid because a sensor
Measurement
error occurred during measurement.
period
No measurement P1-B1
Selecting operations for input errors
Operation will continue if input error enable is set to OFF (disabled) or
OVER (overflow).
A sensor error occurs and all outputs are turned OFF
if the measurement range is exceeded.
Measurement invalid because reset
input received during measurement.
Sensor error No measurement
P.5-29