Omron K3HB-H User Manual page 179

Section 6 User Calibration
6.1 About User Calibration
Calibration Flowchart
(for the K3HB-X/V)
6-2
The K3HB is calibrated correctly at shipment, so there is normally no
need for the user to calibrate it. The K3HB does has a function to
calibrate analog inputs that can be used when required.
Each time data is calibrated, earlier calibration data is overwritten. Be
careful, therefore, because default data is lost when the K3HB is
calibrated by the user.
Prepare measuring instruments and equipment for calibration
separately. Refer to each manual for the instruments and equipment
for information on handling the instruments and equipment.
User calibration is performed according to the following flowchart.
Temporary registration of upper calibration limit
Temporary registration of lower calibration limit
Registration of temporarily registered upper and lower input limits.
Recalibrate.
Turn ON the power supply again and check operation in RUN level.
The input type that can be calibrated according to this flowchart is the
type selected under the "input type A" parameter. To calibrate other
input types, switch the setting for input type A in the initial setting level
to the desired input type and then perform calibration according to the
flowchart outlined above.
Power ON
Move to the calibration level.
Aging
Calibration finished.
Operation
X V S H