Omron K3HB-H User Manual page 80

■ Confirming and Changing Comparative Set Values
Remarks
Knowledge Required for Setting Parameters
Comparative set values are confirmed and changed in RUN level.
(The Unit keeps operating even while comparative set values are being
confirmed and changed.)
The comparative set values from HH to LL are displayed each time the
M [MODE] Key is pressed in the operation status immediately after
the power is turned ON. The SV display status
the displayed comparative set value.
Some comparative set values may not be displayed, depending on the
relay/transistor output specifications and settings.
Refer to the parameter setting procedures for information on how to
change comparative set values.
Power ON er ON
Comparative Comparative
set value HH set value H
M
123. 4
Monitor
125. 0
status
HH
Lights
S
1
*
M
123. 4
Change
125. 0
status
2
*
*1 If no key is pressed for 5 seconds, the set value is registered and the display returns to monitor status.
*2 Use the S [SHIFT] and U [UP] Keys to set the set value.
Displayed Comparative Set Values
Relay/transistor output specifications
H/L Models with Relay Outputs
<C1>
HH/H/L/LL Models with Relays
Outputs <C2>
HH/H/PASS/L/LL Models
with Transistor Outputs
<T1><T2>
None*
* For Sensor Power Supply/Output Models with a PASS Output, the
displayed comparative set value depends on the allocation setting of
the PASS output.
pass (PASS output change)
ll
l
pass
h
hh
err.
Allocating other outputs to PASS output
* When sv. dsp (comparative set value display) is set to OFF,
comparative set values are not displayed during operation but are
displayed with key operations.
HH
Comparative
set value L
M
123. 4 123. 4
124. 0 123. 0
H
L
Lights
Lights
1
* S 1 S
*
M
123. 4 123. 4
124. 0 123.
0
M
Displayed comparative set values
HH H
Displayed comparative set value
HH H
P.5-57
is lit for
H L LL
Comparative
set value LL
M
123. 4
122. 0
LL
Lights
1 S
*
M
M
123. 4
122. 0
L LL
L LL
5-7