Omron K3HB-H User Manual page 86

* If input type A is changed, scaling input values A1 and A2 and scaling display values A1 and
A2 are initialized. The same applies to input type B.
** Input type A is the only choice for all models except the K3HB-S.
B If the PV display is not "in-ta" or "in-
tb," press the M [MODE] Key to
display the desired parameter.
C Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U [UP] Key to change the set
value.
E Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
F Press the L [LEVEL] Key for at least
1 s to return to the RUN level.
Parameter Setting Procedure: Power Supply Frequency*
Set the input type for the K3HB-X/V/H and then set the power supply
frequency.
Perform step E above and then perform the following steps.
G Press the M [MODE] Key several times
to change the PV display to "fre."
H Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV starts to flash.
• Set the frequency to 50 Hz or 60 Hz
to match the local frequency.
5.2 Setting Input Types
M
in-ta
0
L
4-20
S
in-ta
0
L
4-20
U
in-ta
1-5
M
inp. a 1
L
1234. 5
1234. 5
1 s min.
L
fre
0
L
50
L
fre
0
L
50
5-13