Omron K3HB-H User Manual page 144

5.27 Compensating Forced-zero References
Parameter Setting Procedure
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
0" is displayed on the level/bank
• "
L
display to indicate the initial setting
level.
B Press the M [MODE] Key several times
to change the PV display to "amov."
• This parameter is not displayed for the
initial status due to setting level protect.
Refer to "Limiting Key Operations" (P.5-
102) for information on removing setting
level protect.
C Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U [UP] and S [SHIFT] Keys
to set the password "-0169." Press the
M [MODE] Key to move to the
advanced function setting level.
f" is displayed on the level/bank
• "
L
display to indicate the advanced
function setting level.
E Press the M [MODE] Key several times
to switch the PV display to "z-trm."
F Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
G Use the U [UP] Key to change the set
value to "on."
• Change the set value to "off" to turn
OFF zero-trimming.
H Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
I Press the L [LEVEL] Key for at least
1 s to return to the initial setting level.
L
cal
0
L
0
3 s min. 0."
Displays "
L
M
amov
0
L
0
S
amov
0
L
00000
U S
init
f
L
off
f."
Displays "
M
L
M
z-trm
f
L
off
S
z-trm
f
L
off
U
z-trm
f
L
on
M
hp-f
f
L
off
L
0
L
1 s min.
5-71