Not Performing Measurements For Set Intervals - Omron K3HB-H User Manual

5.8 Not Performing Measurements for Set Intervals

f
s-tmr
L
(S-TMR)
5.8 Not Performing Measurements for Set Intervals
With this function measurement is not performed until a set time has
passed after the S-TMR input turns ON. (Timing starts at the rising
edge of the S-TMR input and the PV display is "-----" while no
measurement has been performed.)
If the power is turned ON while the s-tmr input is ON, measurement
will not start until the time set in the s-tmr elapses.
This can be used when detecting motor overloads or to ignore motor
inrush currents.
Parameter
Startup compensation timer
s-tmr
Parameter Setting Procedure
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
0" is displayed on the level/bank
• "
L
display to indicate the initial setting level.
B Press the M [MODE] Key several times
to change the PV display to "amov."
• This parameter is not displayed for the
initial status due to setting level protect.
Refer to "Limiting Key Operations" (P.5-
102) for information on removing setting
level protect.
C Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U [UP] and S [SHIFT] Keys
to set the password "-0169." Press the
M [MODE] Key to move to the
advanced function setting level.
f" is displayed on the level/bank
• "
L
display to indicate the advanced
function setting level.
E Press the M [MODE] Key several times
to change the PV display to "s-tmr."
Advanced function setting level
Set value Meaning of set value
0. 0
Startup compensation timer disabled
0. . 1 to 99. 9
0.1 to 99.9 s
L
3 s min.
M
S
U S
M
M
X V S H
0
L
0."
Displays "
L
amov
0
L
0
amov
0
L
00000
init
f
L
off
f."
Displays "
L
s-tmr
f
L
0. 0
5-27