Holding Comparative Outputs - Omron K3HB-H User Manual

5.20 Holding Comparative Outputs

f
o-stp
L
(O-STP)
The comparative output hold function holds the status of all outputs
after any output except for the PASS output turns ON, i.e., it stops
refreshing outputs. You can choose to stop outputs and continue
measurement, or to stop both.
Outputs will be refreshed again after the reset operation.
• Resetting measurements
● Example with Output Refresh Stop ON
Comparative
set value HH
Comparative
set value H
Comparative
set value L
RESET
Output HH
Output H
Output L
Parameter Set value
Output refresh stop
o-stp
Parameter Setting Procedure
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
0" is displayed on the level/bank
• "
L
display to indicate the initial setting level.
B Press the M [MODE] Key several times
to change the PV display to "amov."
• This parameter is not displayed for the
initial status due to setting level protect.
Refer to "Limiting Key Operations" (P.5-
102) for information on removing setting
level protect.
5.20 Holding Comparative Outputs
Advanced function setting level
P.5-26
Does not turn ON.
Meaning of set value
Outputs
on
Continue
off
Stop
all
Stop
L
3 s min.
M
X V S H
Measurement
Continue
Continue
Stop
0
L
0."
Displays "
L
amov
0
L
0
5-55