Omron K3HB-H User Manual page 79

Section 5 Functions and Operations
■ Monitoring and Changing Set Values
5-6
The value set for a parameter is called the "set value."
Set values can be numerals or characters.
When the SV display is lit, it is called the "monitor status." When the
SV display is flashing, it is called the "change status."
M
Monitor status
int-a
1-5
If no key is pressed for 5 seconds, the
M
set value is registered and the display
returns to monitor status.
To next parameter
Use the following procedure to change set values.
Procedure
A The parameter to be changed is displayed.
• At this stage, the set value is displayed but cannot be changed.
B Press the S [SHIFT] Key once to enable changing the setting.
• The place that can be changed starts to flash.
C Use the S [SHIFT] and U [UP] Keys to change the setting.
D Press the M [MODE] Key to switch to the next parameter.
• The changed set value is stored in the internal memory.
• If no key is pressed at step C for 5 s,* the set value is registered
and the display automatically returns to monitor status.
* If the display is on RUN level or adjustment level, the time before the
return to monitor status depends on the setting for the "automatic
display return time." If the "automatic display return time" setting is
less than 5 s, for example, 3 s, then if there are no key operations in
change status for 3 s, the changed set value is registered and the
display automatically returns to the display when the power was
turned ON.
Change status
S
int-a
1-5
M
Use the S [SHIFT]
and U [UP] Keys to
set the set value.