Changing Normal Display Values To Maximum And Minimum Values - Omron K3HB-H User Manual

Section 5 Functions and Operations
5.30 Changing Normal Display Values to Maximum
and Minimum Values
2
disp
L
(DISP)
5-78
The PV display value displayed after power is turned ON, after the
RESET input, immediately after moving to RUN level, and immediately
after automatic display return to RUN or adjustment levels can be set
to either the present value, maximum value, or minimum value.
The display value selection is set using the following parameter.
Parameter
Display value selection
disp
Parameter Setting Procedure
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
0" is displayed on the level/bank
• "
L
display to indicate the initial setting level.
B Press the L [LEVEL] Key several
times to move to the display adjustment
level.
2" is displayed on the level/bank display
• "
L
to indicate the display adjustment level.
C Press the M [MODE] Key to change
the PV display to "disp."
D Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
E Use the U [UP] Key to change the set
value.
F Press the M [MODE] Key to switch to
the next parameter.
• The set value is registered.
G Press the L [LEVEL] Key for at least
1 s to return to RUN level.
Display adjustment level
Set value Meaning of set value
pv
Present value
max
Max. value
min
Min. value
L
3 s min.
L
M
S
U
M
L
1 s min.
X V S H
0
L
0."
Displays "
L
sv. dsp
2
L
off
2."
Displays "
L
disp
2
L
pv
disp
2
L
pv
disp
2
L
max
ret
2
L
10
123. 4
123. 4