Omron K3HB-H User Manual page 74

Section 5 Functions and Operations
Knowledge Required for Setting Parameters...........................................
------ Operation Adjustments ---------------------------------------------------------------
5.1 Setting Calculations .........................................................................
5.2 Setting Input Types ..........................................................................
5.3 Setting Scaling Values .....................................................................
5.4 Setting the Temperature Unit ...........................................................
5.5 Setting Measurement Operations ....................................................
5.6 Shifting the Temperature Input.........................................................
5.7 Resetting Measurements.................................................................
5.8 Not Performing Measurements for Set Intervals ..............................
------ Input Adjustments----------------------------------------------------------------------
5.9 Selecting Operations for Input Errors...............................................
5.10 Disabling Cold Junction Compensation ...........................................
5.11 Adjusting Timing Inputs ...................................................................
5.12 Eliminating Drift Near "0" .................................................................
5.13 Averaging Inputs ..............................................................................
5.14 Detecting Sudden Input Changes....................................................
------ Output Adjustments -------------------------------------------------------------------
5.15 Changing Comparative Output Patterns ..........................................
5.16 Preventing Output Chattering ..........................................................
5.17 Outputting for a Set Interval .............................................................
5.18 Delaying Output OFF Timing ...........................................................
5.19 Holding Measurement Status ..........................................................
5.20 Holding Comparative Outputs..........................................................
5.21 Allocating Another Output to PASS Output......................................
5.22 Reversing Output Logic ...................................................................
5.23 No Output before PASS Range........................................................
5.24 Performing Linear Output.................................................................
------ Display Adjustments ------------------------------------------------------------------
5.25 Setting the Present Measurement Value to "0" ................................
5.26 Setting the Present Measurement Value to "0" Again when Using a Forced Zero 5-67
5.27 Compensating Forced-zero References ..........................................
5.28 Changing Display Refresh Periods ..................................................
5.29 Holding Maximum and Minimum Values..........................................
5.30 Changing Normal Display Values to Maximum and Minimum Values 5-78
5.31 Setting the Step for Changing the Rightmost Digit ..........................
5.32 Displaying/Not Displaying Comparative Set Values.........................
5.33 Changing Display Colors .................................................................
5.34 Using the Position Meter..................................................................
5.35 Automatic Return to Normal Display................................................
5.36 No Decimal Point Display.................................................................
------ Other Operations -----------------------------------------------------------------------
5.37 Performing Output Tests ..................................................................
5.38 Using Comparative Set Value Banks ...............................................
5.39 Copying Bank Comparative Set Values ...........................................
5.40 Initializing All Settings ...................................................................... 5-100
5.41 Limiting Key Operations ................................................................... 5-102
5-2
5-9
5-11
5-14
5-18
5-19
5-24
5-26
5-27
5-29
5-31
5-33
5-36
5-38
5-41
5-44
5-46
5-49
5-52
5-54
5-55
5-57
5-59
5-61
5-63
5-65
5-70
5-73
5-75
5-80
5-82
5-83
5-85
5-88
5-90
5-92
5-93
5-98
5-1