Omron K3HB-H User Manual page 89

Section 5 Functions and Operations
Scaling
Constant K
(K3HB-S Only)
5-16
Parameter Setting Procedure: Scaling Settings for Input A
The following procedure uses the K3HB-S as an example.
A Press the L [LEVEL] Key for at least
3 s in RUN level to move to the initial
setting level.
0" is displayed on the level/bank
• "
L
display to indicate the initial setting level.
B Press the M [MODE] Key several times
to switch the PV display to "inp. a 1."
• Teaching is possible for scaling input
value A1. "T" is lit to indicate that
teaching is possible.
• Refer to P.5-17 for the teaching
method.
C Press the S [SHIFT] Key to make the
SV display flash.
• The setting can be changed when the
SV display starts to flash.
D Use the U [UP] and S [SHIFT] Keys
to change the set value.
E Press the M [MODE] Key to switch the
PV display to "dsp. a 1."
F Repeat steps C to E and set "dsp. a 1,"
"inp. a2," and "dsp. a2."
Use the same procedure to set the "inp. b1," "dsp. b1," "inp. b2," and
"dsp. b2" parameters for scaling input B (K3HB-S only).
Use steps G to I to set constant K, if required.
Proceed to step J if constant K is not included in the calculation and
does not, therefore, need to be set.
G Press the M [MODE] Key several times
to switch the PV display to "k."
• The set value is registered.
H Press the S [SHIFT] Key to make the
SV display flash.
I Use the U [UP] and S [SHIFT] Keys
to change the set value.
L
cal
0
L
3 s min.
0."
Displays "
L
M
inp. a 1
0
L
4000
"T" is lit.
S
inp. a 1
0
L
4. 000
U S
inp. a 1
0
L
4. 210
M
dsp. a 1
0
L
4000
M
k
0
L
0
S
k
0
L
0
U S
k
0
L
1000