Appendices
No Measurement Status
-----
8
88888
· PV display "-----"
· All outputs OFF
A-30
When no measurement value has been determined, a "no
measurement" status exists. The PV display for no measurement is "-
----" and all outputs are OFF.
A no measurement status occurs in the following circumstances.
• When the power is turned ON during timing hold mode, RESET
input, or startup compensation timer operation.
• Immediately after returning to RUN level from any level other than
the protect and adjustment levels during timing hold mode,
RESET input, or startup compensation timer operation.
• When the
[MAX/MIN] Key is pressed for at least 1 s.
* If the hold signal turns ON when no measurement has been made,
the no measurement status is held.