Setting Logic Operation Methods - Omron ZS-MDC User Manual

Setting the Sensor Controller to Obtain Sensing Information from

Setting Logic Operation Methods

Set how logic operations are to be performed on the tasks and CH specified by the
assignment settings.
FUNMODE-[SENSING]-[CALC]
Setting
OFF
CH
CALC THICK
K-(X+Y)
STEP
X-Y
K+mX+nY
AVE
(average height
measurement)
MAX-MIN
(flatness mea-
surement)
Inputs do not undergo logical operation when "None" is set. Example: The operation "-B" is performed
when "None" is set to input A, "3CH" is assigned to input B and A-B is selected.
Expressions are not set.
Logic operations are not performed, and the measured value of a specific CH
is input as it is.Select the target CH.
Select this item to set the sandwiched thickness. (sandwiched measurement)
• Xrange: input A to input I, TASK1 to TASK4
• Yrange: input A to input I, TASK1 to TASK4
• The thickness input is automatically set.
During thickness input, the mode changes to the measurement
mode, and the current thickness value is displayed on the main dis-
play. For this reason, during thickness input enter in a measurement
ready state.
Select this item to set step measurement. (step measurement)
• Xrange: input A to input I, TASK1 to TASK4
• Yrange: input A to input I, TASK1 to TASK4
Select this to perform logic operations on X and Y with the coefficient freely
set.
• K range: -999999 to 999999
• m range: -10.0 to 10.0
• n range: -10.0 to 10.0
• Xrange: input A to input I, TASK1 to TASK4
• Yrange: input A to input I, TASK1 to TASK4
Select this item to average the values of input A to input I, and the values of
TASK1 to TASK4.
Set ON/OFF to each input and each TASK.The average of inputs set to ON
and TASK is calculated.
Select this item to subtract the maximum and minimum values by the values
of input A to input I.
Set ON/OFF to each input and each TASK.The average of inputs set to ON
and TASK is calculated.
Description
K
X Y
Y X
Section 3
ZS-MDC
3-15
User's Manual