YASKAWA A1000 Series Technical Manual page 43

■ Digital Operator Remote Installation
Digital Operator Dimensions
Installation Types and Required Materials
There are two ways the digital operator can be mounted to an enclosure:
1.
External/face-mount installs the operator outside the enclosure panel
2.
Internal/flush-mount installs the operator inside the enclosure panel
Table 2.2 Digital Operator Installation Methods and Required Tools
Installation Method
Simplified installation with the digital
External/Face-Mount operator is mounted on the outside of
the panel with two screws.
Encloses the digital operator in the
Internal/Flush-Mount panel. The digital operator is flush
with the outside of the panel.
Note: Prevent foreign matter such as metal shavings or wire clippings from falling into the drive during installation and project
construction. Failure to comply could result in damage to the drive. Place a temporary cover over the top of the drive during
installation. Remove the temporary cover before startup, as the cover will reduce ventilation and cause the drive to overheat.
YASKAWA ELECTRIC SIEP C710616 27C YASKAWA AC Drive A1000 Technical Manual
YEG
60
Figure 2.6 Digital Operator Dimensions
Description Installation Support Sets
Installation Support Set A
(for mounting with screws through
holes in the panel)
Installation Support Set B
(for use with threaded studs that are
fixed to the panel)
12.2 Installation holes (2-M3 screws, depth 5)
1.6
S / N : J007XE273710001
7.9
minimum
50
–
EZZ020642A
EZZ020642B
2.2 Mechanical Installation
44
Unit: mm
Model Required Tools
– Phillips screwdriver (#1)
Phillips screwdriver (#1, #2)
Phillips screwdriver (#1)
Wrench (7 mm)
2
43