Drive Label Warnings; Warranty Information - YASKAWA A1000 Series Technical Manual

i.2 General Safety

◆ Drive Label Warnings

Always heed the warning information listed in
Figure i.2
Figure i.3

◆ Warranty Information

■ Restrictions
A1000 was not designed or manufactured for use in devices or systems that may directly affect or threaten human lives
or health.
Customers who intend to use the product described in this manual for devices or systems relating to transportation, health
care, space aviation, atomic power, electric power, or in underwater applications must first contact their Yaskawa
representatives or the nearest Yaskawa sales office.
This product has been manufactured under strict quality-control guidelines. However, if this product is to be installed in
any location where failure of this product could involve or result in a life-and-death situation or loss of human life or in a
facility where failure may cause a serious accident or physical injury, safety devices must be installed to minimize the
likelihood of any accident.
24
Figure i.2 in the position shown in
WARNING
Risk of electric shock.
Read manual before installing.
●
Wait 5 minutes for capacitor
●
discharge after disconnecting
power supply.
To conform to
●
make sure to ground the supply
neutral for 400V class.
After opening the manual switch
●
between the drive and motor,
please wait 5 minutes before
inspecting, performing
maintenance or wiring the drive.
Hot surfaces
Top and Side surfaces may
●
become hot. Do not touch.
Figure i.2 Warning Information
ALM
DIGITAL OPERATOR JVOP-180
F1 F2
LO
ESC
RE
RESET ENTER
RUN STOP
CIMR-AA2A0021FAA
200V 3Phase 5.5kW/3.7kW
S/N:
WARNING AVERTISSMENT NPJT31470-1
Risque de décharge électrique.
Risk of electric shock.
● Read manual before installing. Lire le manuel avant l'installation.
●
● Wait 5 minutes for capacitor Attendre 5 minutes après la coupure
●
discharge after disconnecting de l'alimentation, pour permettre
power supply. la décharge des condensateurs.
● To conform to requirements, Pour répondre aux exigences , s
●
make sure to ground the supply assurer que le neutre soit relié
neutral for 400V class. à la terre, pour la série 400V.
After opening the manual switch Après avoir déconnécte la protection
● ●
between the drive and motor, entre le driver et le moteur, veuillez
please wait 5 minutes before patienter 5 minutes avain d'effectuer
inspecting, performing une opération de montage ou de
maintenance or wiring the drive. câblage du variateur.
Hot surfaces Surfaces Chaudes
Top and Side surfaces may
● ● Dessus et cotés du boitier Peuvent
become hot. Do not touch.
devenir chaud. Ne Pas toucher.
危 険
けが．感電のおそれがあります。
● ● 据え付け、 運転の前には必ず取扱説明書を読むこと。
● 通電中および電源遮断後5分以内はフロントカバー
●
を外さない事。
● 400V級インバータの場合は、電源の中性点が接地
●
されていることを確認すること。( 対応）
保守・点検、配線を行う場合は、出力側開閉器を
●
遮断後5分待って実施してください。
高温注意
● インバータ上部、両側面は高温になります。
● 触らないでください。
Figure i.3 Warning Information Position
YASKAWA ELECTRIC SIEP C710616 27C YASKAWA AC Drive A1000 Technical Manual
Figure
YEG
requirements,
YEG
Warning Label
i.3.