Fpc Leds On The Mx240 Craft Interface; Scb Leds On The Mx240 Craft Interface - Juniper MX240 Hardware Manual

Table 9: DPC and MPC LEDs on the Craft Interface
Label Color
OK Green
–
FAIL Red

FPC LEDs on the MX240 Craft Interface

An FPC takes up two DPC slots when installed in an MX Series router. An FPC LED located along the
bottom of the craft interface indicates status. The LED corresponds to the lowest DPC slot number in
which the FPC is installed. See
Table 10: FPC LEDs on the Craft Interface
Label Color
OK Green
–
FAIL Red

SCB LEDs on the MX240 Craft Interface

Each SCB has two LEDs on the craft interface that indicates its status. The SCB LEDs, labeled 0 and 1/0
(1/0 shows the status of either SCB1 DPC0, or FPC0 depending on which component is installed in the
multifunction slot), are located along the bottom of the craft interface.
functions of the SCB LEDs.
State Description
On Card is functioning normally.
steadily
Blinking Card is transitioning online or offline.
Off The slot is not online.
On Card has failed.
steadily
Table 10 on page 42.
State Description
On FPC is functioning normally.
steadily
Blinking FPC is transitioning online or offline.
Off The slot is not online.
On FPC has failed.
steadily
Table 11 on page 43 describes the
42