Installing An Mx240 Dpc; Figure 105: Removing A Dpc - Juniper MX240 Hardware Manual

See Also
Copyright © 2019, Juniper Networks, Inc.

Figure 105: Removing a DPC

MX240 Dense Port Concentrator (DPC) Description on page 93
MX240 Dense Port Concentrator (DPC) LEDs on page 98
Troubleshooting the MX240 DPCs on page 350

Installing an MX240 DPC

A DPC weighs up to 14.5 lb (6.6 kg). Be prepared to accept its full weight.
To install a DPC (see Figure 106 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Place the DPC on an antistatic mat, or remove it from its electrostatic bag.
2.
Identify the slot on the router where it will be installed.
3.
Verify that each fiber-optic transceiver is covered with a rubber safety cap. If it does
4.
not, cover the transceiver with a safety cap.
Orient the DPC so that the faceplate faces youvertically.
5.
Lift the DPC into place, and carefully align the sides of the DPC with the guides inside
6.
the card cage.
Slide the DPC all the way into the card cage until you feel resistance.
7.
Grasp both ejector handles, and rotate them clockwise simultaneously until the DPC
8.
is fully seated.
Chapter 4: Maintaining, Installing and Replacing Components
263):
261