Replacing Connections To Mx240 Routing Engine Interface Ports - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide
See Also

Replacing Connections to MX240 Routing Engine Interface Ports

240
During the boot, when you see the message
3.
to enter into the BIOS menu boot options.
After the Esc key is pressed,
screen.
Using Up or Down arrow keys, navigate to
4.
Using Up or Down arrow keys, navigate through the EFI boot devices listed and select
5.
to boot from the PXEboot server and press the Enter key.
EFI Network 0 for IPv4
6. Booting `net boot console
NOTE: The booting process may take several minutes.
After the Routing Engine boots, press
7.
vmhost and Junos software on Primary and Secondary disk [y/N]?
After the installation is completed, press y when prompted to confirm
8.
to reboot from the SSD disk.
[y/N]?
Copying vmhost and Junos OS when only one disk is replaced:
a. Bring the Routing Engine online by pressing the
b. The router boots from disk1 if disk2 is replaced. To be able to boot from disk2:
user@host>
request vmhost snapshot partition
The router boots from disk2 if disk1 is replaced. To be able to boot from disk1:
user@host> request vmhost snapshot recovery partition
Returning a Hardware Component to Juniper Networks, Inc. on page 372
Upgrading the SSD Firmware on Routing Engines with VM Host Support
Replacing the Management Ethernet Cable on an MX240 Router on page 241
Replacing the Console or Auxiliary Cable on an MX240 Router on page 241
Press Esc for boot options
Esc is pressed. Go to boot options.
Boot Manager
is displayed and PXEBoot continues.
when you are prompted to confirm
y
ONLINE/OFFLINE
Copyright © 2019, Juniper Networks, Inc.
press Esc key
is displayed on the
and press the Enter key.
Install
on the console.
Reboot now?
button.