Juniper MX240 Hardware Manual page 213

Copyright © 2019, Juniper Networks, Inc.
root@# set interfaces fxp0 unit 0 family inet address address/prefix-length
Configure the IP address of a backup router, which is used only while the routing
10.
protocol is not running.
[edit]
root@# set system backup-router address
Configure the IP address of a DNS server.
11.
[edit]
root@# set system name-server address
Set the root authentication password by entering either a clear-text password, an
12.
encrypted password, or an SSH public key string (DSA or RSA).
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
or
[edit]
root@# set system root-authentication encrypted-password encrypted-password
or
[edit]
root@# set system root-authentication ssh-dsa public-key
or
[edit]
root@# set system root-authentication ssh-rsa public-key
(Optional) Configure the static routes to remote subnets with access to the
13.
management port. Access to the management port is limited to the local subnet. To
access the management port from a remote subnet, you need to add a static route
to that subnet within the routing table. For more information about static routes, see
the Junos OS Administration Library.
[edit]
root@# set routing-options static route remote-subnet next-hop destination-IP retain
no-readvertise
Configure the telnet service at the [edit system services] hierarchy level.
14.
Chapter 3: Initial Installation and Configuration
213