Fpc Leds On The Mx480 Craft Interface; Scb Leds On The Mx480 Craft Interface - Juniper MX480 Hardware Manual

Table 9: DPC and MPC LEDs on the Craft Interface
Label Color
OK Green
–
FAIL Red

FPC LEDs on the MX480 Craft Interface

An FPC takes up two DPC slots when installed in an MX Series router. The LEDs, labeled 0 through 5, are
located along the bottom of the craft interface. The LED corresponds to the lowest DPC slot number in
which the FPC is installed.
Table 10: FPC LEDs on the Craft Interface
Label Color
OK Green
–
FAIL Red

SCB LEDs on the MX480 Craft Interface

Each SCB has two LEDs on the craft interface that indicates its status. The SCB LEDs, labeled 0 and 1, are
located along the bottom of the craft interface.
LEDs.
State Description
On Card is functioning normally.
steadily
Blinking Card is transitioning online or offline.
Off The slot is not online.
On Card has failed.
steadily
Table 10 on page 40 describes the functions of the FPC LEDs.
State Description
On FPC is functioning normally.
steadily
Blinking FPC is transitioning online or offline.
Off The slot is not online.
On FPC has failed.
steadily
Table 11 on page 41 describes the functions of the SCB
40