Juniper MX240 Hardware Manual page 351

Copyright © 2019, Juniper Networks, Inc.
Check the LED on the DPC and
OK/FAIL
When the DPC is online and functioning normally, the
Issue the show chassis fpc
in the sample output, the value
DPC is functioning normally:
user@host> show chassis fpc
Temp CPU Utilization (%)
Slot State (C)
0 Online 41
1 Online 43
2 Online 43
3 Empty
4 Empty
5 Online 42
NOTE: The
show chassis fpc
For more detailed output, add the
a slot number, which is optional:
user@host> show chassis fpc detail
Slot 2 information:
State
Temperature
Total CPU DRAM
Total SRAM
Total SDRAM
Start time
Uptime
Slot 4 information:
State
Temperature
Total CPU DRAM
Total SRAM
Total SDRAM
Start time
Uptime
Slot 7 information:
State
Temperature
Total CPU DRAM
Total SRAM
Total SDRAM
Start time
Uptime
For further description of the output from the commands, see the Junos OS
Administration Library.
and
OK FAIL
command to check the status of installed DPCs. As shown
in the column labeled
Online
Memory
Total Interrupt
9 0
5 0
11 0
6 0
command displays the status of the DPCs.
option. The following example does not specify
detail
Online
22 degrees C / 71 degrees F
1024 MB
256 MB
0 MB
2006-11-03 07:35:40 PST
2 hours, 27 minutes, 1 second
Online
22 degrees C / 71 degrees F
1024 MB
256 MB
0 MB
2006-11-03 07:35:48 PST
2 hours, 26 minutes, 53 seconds
Online
24 degrees C / 75 degrees F
1024 MB
256 MB
0 MB
2006-11-03 07:35:53 PST
2 hours, 26 minutes, 48 seconds
Chapter 5: Troubleshooting Hardware
DPC LEDs on the craft interface.
LED lights green steadily.
OK
indicates that the
State
Utilization (%)
DRAM (MB) Heap Buffer
1024 15
1024 16
1024 16
1024 16
57
57
57
57
351