Mx240 Dpc Port And Interface Numbering - Juniper MX240 Hardware Manual

See Also
Copyright © 2019, Juniper Networks, Inc.
Two Gigabit Ethernet interfaces that allow control information, route information, and
statistics to be sent between the Routing Engine and the CPU on the DPCs.
Two interfaces from the SCBs that enable the DPCs to be powered on and controlled.
Physical DPC connectors.
Two or four Packet Forwarding Engines.
Midplane connectors and power circuitry.
Processor subsystem, which includes a 1.2-GHz CPU, system controller, and 1 GB of
SDRAM.
Online button—Takes the DPC online or offline when pressed.
LEDs on the DPC faceplate. For more information about LEDs on the DPC faceplate,
see the MX Series Interface Module Reference
Two LEDs, located on the craft interface above the DPC, display the status of the DPC
and are labeled and
OK FAIL
MX240 Component LEDs on the Craft Interface on page 36
MX240 Field-Replaceable Units (FRUs) on page 218
Replacing an MX240 DPC on page 259

MX240 DPC Port and Interface Numbering

Each port on a DPC corresponds to a unique interface name in the CLI.
In the syntax of an interface name, a hyphen (
number (represented as an
number in the interface. The second number in the interface corresponds to the logical
PIC number. The last number in the interface matches the port number on the DPC.
Slashes ( ) separate the DPC number from the logical PIC number and port number.
/
type-fpc/pic/port
type—Media type, which identifies the network device. For example:
ge—Gigabit Ethernet interface
so—SONET/SDH interface
xe—10-Gigabit Ethernet interface
For a complete list of media types, see Interface Naming Overview.
fpc—Slot in which the DPC is installed. On the MX240 router, the DPCs are represented
in the CLI as through
FPC 0
pic—Logical PIC on the DPC. The number of logical PICs varies depending on the type
of DPC. For example, a:
.
.
) separates the media type from the DPC
-
FPC in the CLI). The DPC slot number corresponds to the first
.
FPC 2
Chapter 1: Overview
95