Installing An Mx240 As Mxc; Figure 130: Removing An As Mxc - Juniper MX240 Hardware Manual

See Also
Copyright © 2019, Juniper Networks, Inc.

Figure 130: Removing an AS MXC

MX240 Application Services Modular Processing Card Description on page 136
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380

Installing an MX240 AS MXC

To install an AS MXC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Align the notches in the connector at the rear of the AS MXC with the notches in the
2.
AS MXC slot (slot 1—the bottom slot in the AS MLC), and then slide the AS MXC in
until it lodges firmly in the AS MLC.
CAUTION: Slide the AS MXC straight into the slot to avoid damaging the
components on the bottom of the AS MXC.
Use one of the following methods to bring the AS MXC online:
3.
Press the AS MXC offline/online button until the LED light turns green.
Chapter 4: Maintaining, Installing and Replacing Components
Figure 131 on page 310):
309