MX240 5G Universal Routing Platform Hardware Guide
See Also
226
Press the latch located on the inside of the fan tray to release it from the chassis.
4.
Place one hand under the fan tray to support it, and pull the fan tray completely out
5.
of the chassis.
Figure 82: Removing the Fan Tray
Installing the MX240 Normal-Capacity Fan Tray on page 226
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380
Installing the MX240 Normal-Capacity Fan Tray
To install the fan tray (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Grasp the fan tray handle, and insert it straight into the chassis. Note the correct
2.
orientation by the
this side up
Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
3.
Figure 83 on page
227):
label on the top surface of the fan tray.
Copyright © 2019, Juniper Networks, Inc.