Lift; Figure 59: Removing A Power Supply Before Installing The Router - Juniper MX240 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
For an AC-powered router, switch the AC input switch on the power supply to the
2.
off ( ) position. For a DC-powered router, switch the DC circuit breaker on the power
O
supply to the off ( ) position.
O
We recommend this even though the power supplies are not connected to power
sources.
Pull the power supply straight out of the chassis.
3.

Figure 59: Removing a Power Supply Before Installing the Router

Removing the Fan Tray Before Installing the MX240 Router without a Lift
To remove the fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the fan tray faceplate.
2.
Grasp the fan tray handle, and pull it out approximately 1 to 3 inches.
3.
Press the latch located on the inside of the fan tray to release it from the chassis.
4.
Place one hand under the fan tray to support it, and pull the fan tray completely out
5.
of the chassis.
Chapter 3: Initial Installation and Configuration
Figure 60 on page 186 ):
185