Lift; Figure 67: Reinstalling An Scb - Juniper MX240 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
Reinstalling the SCBs After Installing the MX240 Router without a Lift
To reinstall an SCB (see Figure 67 on page
CAUTION: Before removing or replacing an SCB, ensure that the ejector
handles are stored vertically and pressed toward the center of the SCB.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Carefully align the sides of the SCB with the guides inside the chassis.
2.
Slide the SCB into the chassis until you feel resistance, carefully ensuring that it is
3.
correctly aligned.
Grasp both ejector handles and rotate them simultaneously clockwise until the SCB
4.
is fully seated.
Place the ejector handles in their proper position, horizontally and toward the center
5.
of the board. To avoid blocking the visibility of the LEDs position the ejectors over the
PARK icon.

Figure 67: Reinstalling an SCB

Reinstalling the DPCs After Installing the MX240 Router without a Lift
To reinstall a DPC (see Figure 68 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place the DPC on an antistatic mat or remove it from its electrostatic bag.
2.
Identify the slot on the router where it will be installed.
3.
Chapter 3: Initial Installation and Configuration
193):
194):
193