M320 Multiservice Edge Router Hardware Guide
Related
Documentation
M320 Craft Interface Host Subsystem LEDs
Related
Documentation
M320 Craft Interface FPC LEDs and Online/Offline Buttons
Related
Documentation
18
M320 Craft Interface Description on page 15
M320 Craft Interface Alarm LEDs and ACO/LT Button on page 16
Each host subsystem has three LEDs, located in the middle of the craft interface, that
indicate its status. The LEDs labeled
and the CB in slot
RE0
CB0
in slot
RE1
and the CB in slot
subsystem LEDs.
Table 4: M320 Host Subsystem LEDs
Label
Color
Red
FAIL
Green
OK
Green
MASTER
M320 Host Subsystem Description on page 23
M320 Craft Interface Description on page 15
M320 Craft Interface Alarm LEDs and ACO/LT Button on page 16
Each FPC slot has two LEDs that indicate its status. The FPC LEDs, labeled
, are located along the bottom of the craft interface.
FPC7
the functions of the FPC LEDs.
Table 5: FPC LEDs
Label
Color
FAIL
Red
OK
Green
M320 Flexible PIC Concentrator (FPC) Description on page 49
M320 Craft Interface Description on page 15
M320 Connector Interface Panel (CIP) Description on page 13
Troubleshooting the M320 FPCs on page 289
show the status of the Routing Engine in slot
RE0
. The LEDs labeled
show the status of the Routing Engine
RE1
CB1
.
Table 4 on page 18
describes the functions of the host
State
Description
On steadily
Host is offline.
On steadily
Host is online and is functioning normally.
On steadily
Host is functioning as the master.
State
Description
On steadily
FPC has failed.
On steadily
FPC is functioning normally.
Blinking
FPC is starting up.
FPC0
through
Table 5 on page 18
describes
Copyright © 2015, Juniper Networks, Inc.