Dc Power Cable Specifications For The Mx240 Router; Figure 20: Dc Power Cable Lug - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide

DC Power Cable Specifications for the MX240 Router

See Also
56
General Electrical Safety Guidelines and Electrical Codes for MX240 Routers
Site Electrical Wiring Guidelines for MX Series Routers on page 407
DC Power Cable Lug Specifications—The accessory box shipped with the router includes
the cable lugs that attach to the terminal studs of each power supply (see
Figure 20 on page 56).

Figure 20: DC Power Cable Lug

End view
0.28
diameter
0.55
each hole
0.08 0.25 0.625
CAUTION: Before router installation begins, a licensed electrician must attach
a cable lug to the grounding and power cables that you supply. A cable with
an incorrectly attached lug can damage the router.
NOTE: The same cable lug is used for the grounding cable.
DC Power Cable Specifications—You must supply four DC power cables that meet the
following specifications: 6-AWG (13.3 mm
local code.
Connecting Power to a DC-Powered MX240 Router with Normal-Capacity Power
Supplies on page 199
Installing an MX240 DC Normal Capacity Power Supply on page 317
Connecting an MX240 DC Power Supply Cable on page 204
Calculating Power Requirements for MX240 Routers on page 156
DC Power Source Cabling for the MX240 Router on page 55
Site Electrical Wiring Guidelines for MX Series Routers on page 407
2.25
Crimp area
0.37 All measurements in inches
2
), minimum 60° C wire, or as required by the
Copyright © 2019, Juniper Networks, Inc.
6 AWG conductor