Tools Required To Install The Mx240 Router Without A Mechanical Lift; Lift; Without A Lift; Figure 58: Reinstalling An Fpc - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide
See Also

Tools Required to Install the MX240 Router without a Mechanical Lift

Removing Components from the MX240 Router Before Installing it without a Lift
184

Figure 58: Reinstalling an FPC

SC B
SC B
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380
To install the router, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. nut driver
ESD grounding wrist strap
To make the router light enough to install manually, you first remove most components
from the chassis. The procedures in this section for removing components from the
chassis are for initial installation only, and assume that you have not connected power
cables to the router. The following procedures describe how to remove components from
the chassis, first from the rear and then from the front:
Removing the Power Supplies Before Installing the MX240 Router without a
1.
Lift on page 184
Removing the Fan Tray Before Installing the MX240 Router without a Lift on page 185
2.
Removing the SCBs Before Installing the MX240 Router without a Lift on page 186
3.
Removing the DPCs Before Installing the MX240 Router without a Lift on page 187
4.
Removing the FPC Before Installing the MX240 Router without a Lift on page 188
5.
Removing the Power Supplies Before Installing the MX240 Router without a Lift
Remove the leftmost power supply first and then work your way to the right. To remove
the AC or DC power supplies (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Figure 59 on page 185):
Copyright © 2019, Juniper Networks, Inc.