Skoda Octavia III 2013 Workshop Manual page 219

– Loosen catch pegs -arrows- of the cover -1- with disassembly
wedge - 3409- and remove the cover.
– First of all check the plug -arrow- for firm seating.
Note
To do so, pull on the plug without pressing the catch. If the plug
was not correctly plugged in, it may have caused a fault.
– Disconnect the plug -arrow- from the fuel delivery unit.
– Check contacts on plug and on fuel delivery unit for damage.
– Connect test instrument adapter -VAS 5565- to connector and
fuel delivery unit.
– Connect the remote control -V.A.G 1348/3A- to the test instru‐
ment adapter -VAS 5565- and to Battery Plus (+).
Note
This step is only intended to ensure that the fuel delivery unit
♦
runs when the engine is switched off.
The fuel flow rate is measured at 0.4 MPa (4 bar) - this is why
♦
first of all you need to check that the value is correct
⇒ page 208 .
WARNING
Fuel supply line is pressurised! Wear safety goggles and safety
gloves, in order to avoid injuries and skin contact. Place clean‐
ing cloths around the connection point before detaching hose
connections. Then reduce the pressure by carefully removing
the hose.
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
1. Fuel tank and fuel delivery unit
213