Installing - (Yeti) - Skoda Octavia III 2013 Workshop Manual

After deleting the fault memory of the engine control unit the
readiness code must be re-generated.
Caution
There is a risk of destruction of control units as a result of over‐
voltage.
♦ Do not use charger for jump starting!
Tightening torques
Note
Tightening torques apply only for lightly greased, oiled,
♦
phosphatized or blackened nuts and screws.
♦ Other lubricants such as engine and gearbox oil are allowed,
but no lubricants containing graphite.
Do not use degreased parts.
♦
Component
Screws and nuts
deviations:
Engine/gearbox connecting screws ⇒ Gearbox; Rep. gr. 34
Screws for assembly bracket:
♦ Assembly bracket
⇒ "2.1 Assembly bracket - Summary of components (Octavia
III)", page 33 .
1.5

Installing - (Yeti)

Installation is performed in a similar way in the reverse order. Pay
attention to the following points:
– Installing intermediate plate
For vehicles with manual gearbox
– Clean the serration of the drive shaft and if the clutch disc has
been used clean the hub serration, remove existing corrosion
and only apply a very thin layer of grease - G 000 100- to the
serration of the drive shaft.
– Subsequently move the clutch disc up and down on the drive
shaft until the hub fits smoothly on the shaft. Always remove
excess grease.
– Check the centering of the clutch disc ⇒ Gearbox; Rep. gr.
30 .
– Check the clutch release bearing for wear. Replace release
bearing if worn ⇒ Gearbox; Rep. gr. 30 .
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
Nm
M6 9 Nm
M7 15 Nm
M8 20 Nm
M10 40 Nm
M12 65 Nm
⇒ page 57 .
1.6/81 kW MPI engine - Edition 06.2014
1. Removing and installing engine
29