Skoda Octavia III 2013 Workshop Manual page 65

– Turn engine shaft further in direction of arrow so that the
screwdriver just out at the top by approx. 35 mm in the
-direction of the arrow-.
– Unscrew locking screw for "TDC" bore at the cylinder block
⇒ page 88 .
Caution
Risk of engine damage.
If the fixing screw - T10340- cannot be screwed in up to the
stop, the crankshaft is not in the correct position.
In this case, proceed as follows:
♦ Unscrew the fixing screw.
♦ Set the correct position of the crankshaft for screwing in
the fixing screw ⇒ page 58
– Turn the fixing screw - T10340- up to the stop in the cylinder
block and tighten to 30 Nm.
– Turn crankshaft up to the stop in direction of rotation of engine.
• The crankshaft sprocket now lies on the fixing screw and the
"TCD" position is set.
Note
The crankshaft is only locked in direction of rotation of engine
using the fixing screw - T10340- .
– Remove sump top part
– Remove the engine speed sender - G28- -arrow-
⇒ page 272 .
– Undo screws -1 ... 6-.
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
.
⇒ page 132 .
1.6/81 kW MPI engine - Edition 06.2014
2. Cylinder block, gearbox end
59