Skoda Octavia III 2013 Workshop Manual page 29

– Release nut -arrow- on left and right for swivel hub.
– Unhook swivel hub from track control arm on left and right for
swivel hub.
For vehicles with manual gearbox
– Remove shift mechanism from gearbox ⇒ Gearbox; Rep. gr.
34 .
– Remove slave cylinder ⇒ Gearbox; Rep. gr. 30 .
– Unscrew drive shaft from the transmission left and right ⇒
Axles, steering; Rep. gr. 40 and attach to the bodyshell.
For models with automatic gearbox
– Remove selector lever linkage, remove transmission connec‐
tor and remove all mounting brackets from transmission ⇒
Gearbox 09G; Rep. gr. 34 .
– Slide drive shaft off the transmission left and right ⇒ Axles,
steering; Rep. gr. 40 and secure to the bodyshell.
Continued for all vehicles
– Swivel out the suspension strut outwards towards the left and
support with the extension of the lifting device -MP9-201
(2024A)- as shown.
WARNING
There is a risk of accidents caused by loose parts of the sup‐
port.
♦ Secure rig pin with plug-in lock and swivel hub -arrow- with
nut -1-.
– Screw swivel hub -2- right at the track control arm -1- tight
using the nut -arrow-, as shown in the illustration.
Note
Ensure that the surface protection of the cardan shaft is not dam‐
aged.
– Undo screws -1-, -2-, -3- and remove the pendulum support
-4-.
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
1. Removing and installing engine
23