Mixture Preparation - Injection; Injection System; Injection System - Fitting Location Of The Injection System - Skoda Octavia III 2013 Workshop Manual

24 –

Mixture preparation - injection

1

Injection system

⇒ "1.1 Injection system - Fitting location of the injection system",
page 229
1.1 Injection system - Fitting location of the
injection system
⇒ "1.1.1 Engine compartment - Overview of fitting locations (Oc‐
tavia III)", page 229
⇒ "1.1.2 Engine compartment - Overview of fitting locations (Ye‐
ti)", page 230
⇒ "1.1.3 Installation location overview - engine from front",
page 231
⇒ "1.1.4 Installation location overview - engine from rear",
page 232
1.1.1 Engine compartment - Overview of fitting locations (Octavia III)
1 - Inlet camshaft control valve
1 - N205-
❑ schemat montażowy
⇒ page 77
2 - lambda probe - G39- and
heating for lambda probe -
Z19-
❑ schemat montażowy
⇒ page 249
3 - Lambda probe downstream
of catalytic converter - G130-
and heater of lambda probe 1
downstream of catalytic con‐
verter - Z29-
❑ schemat montażowy
⇒ page 249
4 - Hall sender - G40- (cam‐
shaft position sensor)
❑ schemat montażowy
⇒ page 269
5 - Engine control unit - J623-
❑ removing and installing
⇒ page 252
6 - Coolant temperature send‐
er at radiator outlet - G83-
❑ removing and installing
⇒ page 163
7 - intake air temperature
sender - G42- / intake manifold
pressure sender - G71-
❑ schemat montażowy
⇒ page 236
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
229
1. Injection system