Skoda Octavia III 2013 Workshop Manual page 33

For models with automatic gearbox
– Replace the needle bearing -arrow- in the crankshaft
⇒ page 67 .
Continued for all vehicles
– Installing the gearbox ⇒ Gearbox; Rep. gr. 34 .
– Install gearbox support bracket.
– Take up engine/gearbox unit with the engine mount T10497 .
– Position engine/gearbox unit with the engine mount - T10497-
on the engine and gearbox jack - V.A.G 1383 A- .
Note
Replace screws which have been tightened firmly to a torque‐
♦
ing angle.
Replace self-locking nuts and screws as well as gasket rings,
♦
gaskets and O-rings.
Secure all hose connections with hose clamps which comply
♦
with the series design ⇒ Electronic Catalogue of Original
Parts"ETKA"
All cable straps should be fastened again in the same place
♦
when installing.
– Insert engine/gearbox unit into the body.
– Initially insert screws -arrows- for engine mount by hand as far
as the stop.
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
1. Removing and installing engine
27