Aligning Exhaust System - Skoda Octavia III 2013 Workshop Manual

– Separate exhaust pipe at right angles at the separation point
arrow -2- with body saw.
– Remove screws for suspensions and remove parts of the ex‐
haust system.
Install
Installation is performed in a similar way in the reverse order. Pay
attention to the following points:
– When installing clamping sleeve -4- position on the side mark‐
ings arrow -1- and arrow -3-.
Installation position of rear clamp
– Install clamping sleeve in the position shown.
• Angle -α- = approximately 20°.
• Nuts upwards.
• 30 Nm
– Installing front clamping sleeve
– Align exhaust system in cold condition free of stress
⇒ page 267 .
Tightening torques
• Middle and rear silencer
⇒ "1.3 Middle or rear part of the exhaust system - Summary of
components (Yeti)", page 262
• Front clamping sleeve
⇒ "1.1 Pre-exhaust pipe with catalytic converter - Summary of
components", page 259
• Remove the tunnel bridge and underbody cover ⇒ Body Work;
Rep. gr. 66
1.7

Aligning exhaust system

⇒ "1.7.1 Aligning exhaust system free of stress", page 267
⇒ "1.7.2 Align exhaust tailpipe", page 268
1.7.1 Aligning exhaust system free of stress
• The exhaust system is aligned when cold.
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
⇒ page 261 .
1.6/81 kW MPI engine - Edition 06.2014
1. Removing and installing exhaust system
267